TRANSMITTER FOR AKIA WHEELED MOTOR DRIVE
What is a transmitter for automation equipment?
A transmitter is a device which sends a command to a receiver installed on a device, in our case wheeled automation equipment, to control it.
- The transmitter can be a remote control, a keypad or a key switch.
- Mgh determines the command transmission speed.
- The code is the encryption of your command and the receiver must be able to decipher it.
Transmitter, remote control, keypad, etc. to control your Akia
On AKIA System’s wheeled motor drives, simply press the remote control to open the gate. If you press it while the gate is in motion, the gate stops immediately. Press it again and the gate goes in the opposite direction. Complete opening
A second programme (on a 2nd button of the remote control) allows a single leaf to open partially. It can be closed by pressing the remote again, or programmed to close automatically in timer mode. Partial opening
These operations are identical with our various control devices such as digital entry codes, door openers, push buttons or key safes.
It is possible to add a module which can be plugged into the AKIA PU2M circuit board, with a remote control switch, timer, pulsed or two-way function, to enable the use of a third channel.
FLO 4-channel remote control
The Nice Flo 4-channel remote control is a fixed-code programmable 433 Mgh radio control with numerous dip switch settings.
Stylish and robust, 7cm high, 4cm wide and 1.6cm thick
STYLO 4 King Gates remote control
The King Gates Stylo 4-channel remote control is a 433 Mgh rolling-code remote control.
Stylish and unobtrusive, 7cm long, 4cm wide and 1.2cm thick.
433 Mhz 4-channel radio keypad
The 433 Mhz 4-channel radio keypad features a steel case and metal keys to ensure protection against tampering.
It has 4 channels for 4 different functions and 8 slave codes for different users, each with 4 independent functions.
It is equipped with LED lighting 10 seconds from the initial contact.
Its dimensions are 114 x 77 x 70 mm.
12/24V AC/DC wired keypad
The 12/24V AC/DC wired keypad features 2 relays and 60 codes. Its keys are made of plastic and the case of grey polycarbonate.
Its dimensions are 105 x 85 x 40 mm.
NOVO CLICK key switch
The NOVO-CLICK key switch features 2 surface-mounted contacts with pre-wired micro-switches. It can be installed horizontally or vertically. It is equipped with an anti-theft system with customised key and comes with 2 keys.
Very stylish design; dimensions: 104 x 60 x 30 mm.
Flush-mounted key switch
The flush-mountable key switch, with 2 NO contacts and same key, is flush-mounted.
Its dimensions are 75 x 75 x 45 mm.